chthemonkey
2011-09-12T15:00:38Z
can anyone help with info on fitting a accelerator return spring
any help
thanks
chris
Sponsor


(Register and log-in to hide thread adverts)
JD
  •  JD
  • pre67vw Junkie
2011-09-13T14:54:50Z
Should be one on the carb. Isn´t it up to the job?
There´s also a small one behind the pedal (unless you have a roller).
"John, you need to get a grip and STOP MOANING AT EVERYTHING. ThumbDown "
UserPostedImage
69project
2011-09-13T16:53:46Z
depends what one you mean..

there are two on the pedal depending what year you have,on a non roller there is the spindly one that needs the pedal pin removing but ive never bothered with this or the smaller tighter one that holds the pedal linkage arm together.i found different manufacturers did different tension levels which is quite difficult to do

if its the carb spring then kk do a kit for this,found that the holding washer/plate got in the way and a few washers needed on repro spring to give desired seating of carb for settled idle
Car less.....
chthemonkey
2011-09-13T17:04:35Z
i got the larger roller pedal and ordered this when i was ordering other bits https://www.vwheritage.c...1_lang_EN_country_GB.htm 
there's a new carb on thats fine the pedal just stops when pressed
thanks
chris
Similar Topics
Users browsing this topic