kevsplitty
10 years ago
Having just rebuilt my stock 1500sp engine in my single cab,its now done about 200miles but i can't seem to get it running perfectly,have checked timing,valve clearances,been through the carb but still getting same problem. It runs fine but when i go to pull away or change up gears then put my foot on floor its jerky,stutters etc till i whack my foot flat on the floor! I replaced the heads with other 1500 heads & these had larger inlet valves,would this of made a difference? would i need to put a larger jet in the carb now maybe? Any ideas appreciated thanks,

kev
Sponsor


(Register and log-in to hide thread adverts)
JD
  • JD
  • pre67vw Junkie
10 years ago
Could it be that the preheat pipe is blocked and icing the carb?
Or the distributor advance/knackered vacuum advance?
"John, you need to get a grip and STOP MOANING AT EVERYTHING. ThumbDown "
UserPostedImage
kevsplitty
10 years ago
I'll check those,many thanks!

Kev
AW
  • AW
  • pre67vw Junkie
10 years ago
Is the pump jet on the carb working corectley ????????????


Andy W
kevsplitty
10 years ago
Distributor is working fine & dont think its the prehaet pipe as it does it when hot also,which brings me back to the carb again!!!!
I'll check the pump jet.
Thank you:wink:
Copyright © Rob Amos 2019. No part of this site can be reproduced without consent. | Terms & Conditions | Privacy Policy | Contact