Hello all!

As some of you may know, I am currently doing some rust repair to my 63 beetle. However, previous bodges have left me with little to go by in the way of fabrication in some areas and there do not seem to be (by god ive looked) detailed photos of some areas?

The area im interested in is where the decklid sits, and where the top edge of the rear valence is welded to. Because mine has had plates over this area and the valence has been off before, I have no idea what this area should look like in the way of pressings with the valence off? Can anyone help?

This area! :? :wink:

ANY photos of this area, ideally with the valnce removed would be greatly apreciated! :d




Cheers!

Will :beer:

---

Will, pm your email address and I'll sent some more.  ready to prime 010 (2).jpg You have insufficient rights to see the content.

---

PM sent and thanks! :wink: 😎

---

If you could just cut along this line (keep the valence) and post it to me that would be great! :d :beer:







:wink: :shock:

---

Sorry Will, the wings are on now so would be a bit tricky..:lol: :lol:

---

No probs, ill take those to! :wink:

---